Radiant Imaging Labs

Face Selection

Draft: not yet checked against the release

Face Selection shows the faces Radiant Photo found in your photo. The portrait tools in Eyes, Face, Skin and Makeup retouch exactly these faces, so check here first when a retouch doesn't look right. It's in the right panel, just above Eyes (press A).

ControlWhat it does
Face thumbnail (Face 1, Face 2…)Click it to select the face and zoom the photo to it.
x on a thumbnailRemoves the face (tooltip Remove face 2 for Face 2). The portrait tools leave it alone.
+Manually add face: place a face the detector missed.
Eye-point buttonAdjust eye center points of the selected face.
ResetBrings back the faces as Radiant Photo found them. It appears once you add, move or remove a face.

While the photo loads, the section says Loading photo… and then Detecting faces…. If there's no one in the photo, it says No faces detected in this photo.

Zoom to a face

Click a face's thumbnail. The photo zooms to that face and centers it. Click the same thumbnail again to come back to it after you pan away.

Selecting a face doesn't limit the portrait tools to that face. They always work on every face in the list.

Add a face the detector missed

Faces in profile, in deep shade, behind sunglasses or very small in the frame are the usual misses.

  1. Click + (Manually add face).
  2. Click the first eye on the photo, then the second, from screen left to right. The hint reads Click the first eye, then the second (screen left to right), to place a face.
  3. Click Apply.

The new face joins the list and is selected. The portrait tools, Face Light included, start working on it at once.

You can also place a face from the keyboard. Move the reticle with the arrow keys, press Return (Enter on Windows) or Space to drop an eye, and press Esc to cancel. A screen reader announces Placing first eye or Placing second eye as you go.

Note

Clicks outside the photo, or inside a face that's already in the list, are ignored. Two clicks in almost the same spot can't make a face.

Move the eye points

The eye centers guide where several Eyes and Face corrections go. If they're slightly off, move them.

  1. Click the face's thumbnail to select it.
  2. Click Adjust eye center points.
  3. Drag either eye point to the center of the eye.
  4. Click Apply, or press Return (Enter on Windows). Press Esc to leave the face as it was.

You can adjust any face, including the ones Radiant Photo found. Moving the points by a small amount doesn't move the corrections by exactly the same amount, so try a few positions and judge the result.

Remove a face

Click the x on a face's thumbnail. The portrait tools stop retouching that face, for example a stranger in the background.

Undo and reset

Adding, moving and removing a face are each one undo step: press ⌘Z (Ctrl+Z on Windows). To start over, click the reset button in the section header. It brings back every face as Radiant Photo found it.

Learn more