Radiant Imaging Labs

Looks and Workflows

Draft: not yet checked against the release

This lesson takes about four minutes. On a photo of a canal lined with painted houses, you see which scene your Workflow chose, try another scene, and add a Look.

The lesson runs on a sample photo, not on your own photos. Radiant Photo downloads the sample the first time, so you need an internet connection once. When the lesson closes, the sample is put away and your own photo comes back as you left it.

Start the lesson

Open this page in the Help window and start the lesson there, or pick it from the list of tours in Help. In Read & learn you do each step yourself. In Watch & see, Radiant Photo plays the steps, but it does not pick a Look for you. Pause at the Collection step, apply a Look yourself, and play again. The three sliders after it then move by themselves.

What you do

  1. Look at the Scene: line in the Workflow section on the left. Your Workflow matched the photo to a scene and applied the recipe made for it.
  2. Click Override scene to open the list of scenes, and choose a different scene. The photo takes on that scene's recipe.
  3. Click Use Scene to bring back the settings Radiant Photo chose.
  4. The Looks Showcase opens, with each Look shown on the photo. Click Next step in the Help window to go on.
  5. Open the Collection list and choose Color Film Stocks. The Showcase starts with every collection, one after another, and the list takes you straight to one. If the Looks are below the edge of the window, scroll down in the Showcase.
  6. Click the Look named Pop Film to apply it. Then set Strength to 50 for a lighter touch.
  7. Set Look Contrast to 25.
  8. Set Look Saturation to 30.
  9. Click Close showcase. The Look stays on the photo.

Note

A Look you apply in the lesson joins your recently used Looks.

Next